Tees, Tees and more tees
Our investment in a Kornit printer was a wise move. We purchased the unit with some reluctance because of the price.
You can expect to spend close to $300,000.00 for a new machine. We bit the bullet and purchased three. We never looked back.
Some say we could get more production if we purchased the less expensive DTG printers available. This argument sounds good if you are shopping price.
Bargin Priced DTG printers are suspect
We found that the lesser priced printers are not fit for production. These machines work real well if your market is geared to single shirt printing. The margins are great for one off printing.
If you are going to use a lesser priced model you have to be aware of the time to print a shirt. They just do not perform as advertised.
DTG Production time
We found that the printing process is slowed down due to the application of the pretreatment. Each shirt has to be pretreated before printing. The process is to first spray the pretreatment on the garment and heat press to lay the fibers of the garment down for printing. With the Kornit the pretreatment is included in the printing cycle. This is a important time saver to consider if you are going to do production. The pretreatment process generally takes about 2 minutes vs no time using a Kornit.
The next step after pretreatment is to print the garment. Time in a Kornit is around 2 minutes or less in the new machines. In a mall style printer the time is about 4 minutes.
Finishing the shirt
After printing the garment has to be heat pressed again to finish. Using a Kornit we run the garment though a dryer and the project is complete. The dryer does take a little longer but it does not eat up labor time like a heat press machine does.
In summary we make tees, tees and more tees than a lower priced DTG printer.
Both systems are good but you can make some real money with the Kornit.